SN65LBC184 瞬态电压抑制差动收发器
The SN75LBC184 and SN65LBC184 are differential data line transceivers in the trade-standard footprint of the SN75176 with built-in protection against high-energy noise transients. This feature provides a substantial increase in reliability for better immunity to noise transients coupled to the data cable over most existing devices. Use of these circuits provides a reliable low-cost direct-coupled (with no isolation transformer) data line interface without requiring any external components.
The SN75LBC184 and SN65LBC184 can withstand overvoltage transients of 400-W peak (typical). The conventional combination wave called out in IEC 61000-4-5 simulates the overvoltage transient and models a unidirectional surge caused by overvoltages from switching and secondary lightning transients
|
SN65LBC184 |
| Drivers Per Package |
1 |
| Receivers Per Package |
1 |
| Supply Voltage(s)(V) |
5 |
| ESD(kV) |
15 |
| Temp Range(C) |
-40 to 85 |
| Signaling Rate(Mbps) |
0.25 |
| ICC(Max)(mA) |
25 |
| Fail Safe |
Open |
| Isolated |
No |
| # of TX/RX |
1 TX / 1 RX |
| Common Mode Range |
-7 to 12 |
| Number of Nodes |
128 |
| Duplex |
Half |
| Footprint |
SN75176 |
| Comments |
Integrated Transient Protection, IEC 61000-4-2/5 |
| Pin/Package |
8PDIP, 8SOIC |
| Rating |
Catalog |
| Fault Protection(V) |
-15 to 15 |
SN65LBC184 特性
- Integrated Transient Voltage Suppression
- ESD Protection for Bus Terminals Exceeds:
- ±30 kV IEC 61000-4-2, Contact Discharge
- ±15 kV IEC 61000-4-2, Air-Gap Discharge
- ±15 kV EIA/JEDEC Human Body Model
- Circuit Damage Protection of 400-W Peak (Typical) Per IEC 61000-4-5
- Controlled Driver Output-Voltage Slew Rates Allow Longer Cable Stub Lengths
- 250-kbps in Electrically Noisy Environments
- Open-Circuit Fail-Safe Receiver Design
- 1/4 Unit Load Allows for 128 Devices Connected on Bus
- Thermal Shutdown Protection
- Power-Up/-Down Glitch Protection
- Each Transceiver Meets or Exceeds the Requirements of TIA/EIA-485 (RS-485) and ISO/IEC 8482:1993(E) Standards
- Low Disabled Supply Current 300 uA Max
- Pin Compatible With SN75176
- Applications:
- Industrial Networks
- Utility Meters
- Motor Control
SN65LBC184 芯片订购指南
| 器件 |
状态 |
温度 |
价格 |
封装 | 引脚 |
封装数量 | 封装载体 |
丝印标记 |
| SN65LBC184D |
ACTIVE |
-40 to 85 |
2.35 | 1ku |
SOIC (D) | 8 |
75 | TUBE |
|
| SN65LBC184DG4 |
ACTIVE |
-40 to 85 |
2.35 | 1ku |
SOIC (D) | 8 |
75 | TUBE |
|
| SN65LBC184DR |
ACTIVE |
-40 to 85 |
2.00 | 1ku |
SOIC (D) | 8 |
2500 | LARGE T&R |
|
| SN65LBC184DRG4 |
ACTIVE |
-40 to 85 |
2.00 | 1ku |
SOIC (D) | 8 |
2500 | LARGE T&R |
|
| SN65LBC184P |
ACTIVE |
-40 to 85 |
2.35 | 1ku |
PDIP (P) | 8 |
50 | TUBE |
|
| SN65LBC184PE4 |
ACTIVE |
-40 to 85 |
2.35 | 1ku |
PDIP (P) | 8 |
50 | TUBE |
|
SN65LBC184 质量与无铅数据
| 器件 |
环保计划* |
铅/焊球涂层 |
MSL 等级/回流焊峰 |
环保信息与无铅 (Pb-free) |
DPPM / MTBF / FIT 率 |
| SN65LBC184D |
Green (RoHS & no Sb/Br) |
CU NIPDAU |
Level-1-260C-UNLIM |
SN65LBC184D |
SN65LBC184D |
| SN65LBC184DG4 |
Green (RoHS & no Sb/Br) |
CU NIPDAU |
Level-1-260C-UNLIM |
SN65LBC184DG4 |
SN65LBC184DG4 |
| SN65LBC184DR |
Green (RoHS & no Sb/Br) |
CU NIPDAU |
Level-1-260C-UNLIM |
SN65LBC184DR |
SN65LBC184DR |
| SN65LBC184DRG4 |
Green (RoHS & no Sb/Br) |
CU NIPDAU |
Level-1-260C-UNLIM |
SN65LBC184DRG4 |
SN65LBC184DRG4 |
| SN65LBC184P |
Pb-Free (RoHS) |
CU NIPD |
N/A for Pkg Type |
SN65LBC184P |
SN65LBC184P |
| SN65LBC184PE4 |
Pb-Free (RoHS) |
CU NIPD |
N/A for Pkg Type |
SN65LBC184PE4 |
SN65LBC184PE4 |
SN65LBC184 应用技术支持与电子电路设计开发资源下载
- SN65LBC184 数据资料 dataSheet 下载.PDF
- TI 德州仪器RS-485选型与价格 . xls
- 所选封装材料的热学和电学性质 (PDF 645 KB)
- 使用数字隔离器设计隔离式 I2C 总线接口 (zhct119.PDF, 339 KB)
- 1Q 2011 Issue Analog Applications Journal (slyt399.PDF, 964 KB)
- 接口选择指南 (Rev. D) (PDF 2994 KB)
- Signaling Rate vs. Distance for Differential Buffers (PDF 420 KB)
- Q1 2009 Issue Analog Applications Journal (slyt319.PDF, 1.39 MB)
- Isolated RS-485 Reference Design (PDF 80 KB)
- 无铅组件涂层的保存期评估 (PDF 1305 KB)
- Analog Signal Chain Guide (8.62 MB)
- Industrial Interface IC Solutions (101 KB)
SN65LBC184 工具和软件