The 'S124 features two independent voltage-controlled oscillators (VCO) in a   single monolithic chip. The output frequency of each VCO is established by an   external capacitor in combination with two voltage-sensitive inputs, one for   frequency range and one for frequency control. These inputs can be used to vary   the output frequency as shown under typical characteristics. These highly stable   oscillators can be set to operate at any frequency typically between 0.12 hertz   and 85 megahertz.
While the enable input is low, the output is enabled. While the enable input is high, the output is high.
These devices can operate from a single 5-volt supply. However, one set of   supply-voltage and ground pins (VCC and GND) is provided for the   enable, synchronization-gating, and output sections, and a separate set (
 GND) and is   provided for the oscillator and associated frequency-control circuits so that   effective isolation can be accomplished in the system
| SN54S124 | |
| Voltage Nodes(V) | 5 | 
| Rating | Military | 
| Technology Family | S | 
| 器件 | 状态 | 温度 | 价格(美元) | 封装 | 引脚 | 封装数量 | 封装载体 | 丝印标记 | 
| SN54S124J | ACTIVE | -55 to 125 | 6.60 | 1ku | CDIP (J) | 14 | 1 | TUBE | |
| SNJ54S124FK | ACTIVE | -55 to 125 | 12.91 | 1ku | LCCC (FK) | 20 | 1 | TUBE | |
| SNJ54S124J | ACTIVE | -55 to 125 | 7.75 | 1ku | CDIP (J) | 14 | 1 | TUBE | 
| 器件 | 环保计划* | 铅/焊球涂层 | MSL 等级/回流焊峰 | 环保信息与无铅 (Pb-free) | DPPM / MTBF / FIT 率 | 
| SN54S124J | TBD | A42 | N/A for Pkg Type | SN54S124J | SN54S124J | 
| SNJ54S124FK | TBD | POST-PLATE | N/A for Pkg Type | SNJ54S124FK | SNJ54S124FK | 
| SNJ54S124J | TBD | A42 | N/A for Pkg Type | SNJ54S124J | SNJ54S124J |