首页 > TI 德州仪器 > 接口 > RS-232

TRS3222 具有 +/-15kV ESD 保护的 3V 至 5.5V 多通道 RS-232 线路驱动器/接收器

The TRS3222 consists of two line drivers, two line receivers, and a dual charge-pump circuit with ±15-kV ESD protection pin to pin (serial-port connection pins, including GND). The device meets the requirements of TIA/EIA-232-F and provides the electrical interface between an asynchronous communication controller and the serial-port connector. The charge pump and four small external capacitors allow operation from a single 3-V to 5.5-V supply. The device operates at data signaling rates up to 250 kbit/s and a maximum of 30-V/u s driver output slew rate.

The TRS3222 can be placed in the power-down mode by setting PWRDOWN low, which draws only 1 u A from the power supply. When the device is powered down, the receivers remain active while the drivers are placed in the high-impedance state. Also, during power down, the onboard charge pump is disabled; V+ is lowered to VCC, and V- is raised toward GND. Receiver outputs also can be placed in the high-impedance state by setting EN high

TRS3222
Data Rate(kbps) 250
Drivers Per Package 2
Receivers Per Package 2
ESD HBM(kV) +/-15
Supply Voltage(s)(V) 3.3 or 5.0
ICC(Max)(mA) 1
Operating Temperature Range(°C) 0 to 70
Pin/Package 20SSOP
Approx. Price (US$) 1.30 | 1ku
Rating Catalog
Footprint MAX3222
TRS3222 特性
TRS3222 芯片订购指南
器件 状态 温度 价格 封装 | 引脚 封装数量 | 封装载体 丝印标记
TRS3222CDBR ACTIVE 0 to 70 1.00 | 1ku SSOP (DB) | 20 2000 | LARGE T&R  
TRS3222CDBRG4 ACTIVE 0 to 70 1.00 | 1ku SSOP (DB) | 20 2000 | LARGE T&R  
TRS3222 质量与无铅数据
器件 环保计划* 铅/焊球涂层 MSL 等级/回流焊峰 环保信息与无铅 (Pb-free) DPPM / MTBF / FIT 率
TRS3222CDBR Green (RoHS & no Sb/Br) CU NIPDAU Level-1-260C-UNLIM TRS3222CDBR TRS3222CDBR
TRS3222CDBRG4 Green (RoHS & no Sb/Br) CU NIPDAU Level-1-260C-UNLIM TRS3222CDBRG4 TRS3222CDBRG4
TRS3222 应用技术支持与电子电路设计开发资源下载
  1. TRS3222 数据资料 dataSheet 下载.PDF
  2. TI 德州仪器RS-232 产品选型与价格 . xls
  3. Analog Signal Chain Guide (8.62 MB)
  4. Industrial Interface IC Solutions (101 KB)