首页 > TI 德州仪器 > 接口 > RS-232

TRS213 具有 +/-15kV ESD 保护的 5V 多通道 RS-232 线路驱动器/接收器

The TRS213 device consists of four line drivers, five line receivers, and a dual charge-pump circuit with ±15-kV ESD protection pin to pin (serial-port connection pins, including GND). The device meets the requirements of TIA/EIA-232-F and provides the electrical interface between an asynchronous communication controller and the serial-port connector. The charge pump and four small external capacitors allow operation from a single 5-V supply. The devices operate at data signaling rates up to 120 kbit/s and a maximum of 30-V/us driver output slew rate.

The TRS213 has an active-low shutdown (SHDN) and an active-high enable control (EN). In shutdown mode, the charge pumps are turned off, V+ is pulled down to VCC, V- is pulled to GND, and the transmitter outputs are disabled. This reduces supply current typically to 1 uA. Two receivers of the TRS213 are active during shutdown

TRS213
Data Rate(kbps) 120
Drivers Per Package 4
Receivers Per Package 5
ESD HBM(kV) +/-15
Supply Voltage(s)(V) 5.0
ICC(Max)(mA) 20
Operating Temperature Range(°C) -40 to 85,0 to 70
Pin/Package 28SOIC, 28SSOP
Approx. Price (US$) 1.00 | 1ku
Rating Catalog
Footprint MAX213
TRS213 特性
TRS213 芯片订购指南
器件 状态 温度 价格 封装 | 引脚 封装数量 | 封装载体 丝印标记
TRS213CDBR ACTIVE 0 to 70 1.00 | 1ku SSOP (DB) | 28 2000 | LARGE T&R  
TRS213CDBRG4 ACTIVE 0 to 70 1.00 | 1ku SSOP (DB) | 28 2000 | LARGE T&R  
TRS213 质量与无铅数据
器件 环保计划* 铅/焊球涂层 MSL 等级/回流焊峰 环保信息与无铅 (Pb-free) DPPM / MTBF / FIT 率
TRS213CDBR Green (RoHS & no Sb/Br) CU NIPDAU Level-1-260C-UNLIM TRS213CDBR TRS213CDBR
TRS213CDBRG4 Green (RoHS & no Sb/Br) CU NIPDAU Level-1-260C-UNLIM TRS213CDBRG4 TRS213CDBRG4
TRS213 应用技术支持与电子电路设计开发资源下载
  1. h 数据资料 dataSheet 下载.PDF
  2. TI 德州仪器RS-232 产品选型与价格 . xls
  3. Analog Signal Chain Guide (8.62 MB)
  4. Industrial Interface IC Solutions (101 KB)