TLK3138 Dual XAUI Transceiver
The TLK3138 is an eight channel serial transceiver. It is compliant with the 10Gbps Ethernet XAUI specification. The TLK3138 provides 10 Gbps high-speed bi-directional point-to-point data transmission. The primary application of this device is in backplanes and front panel connections requiring dual/redundant 10Gbps connections over controlled impedance media of approximately 50Ω. The transmission media can be printed circuit board (PCB) traces, copper cables or fiber-optical media. The ultimate rate and distance of data transfer is dependent upon the attenuation characteristics of the media and the noise coupling into the lines.
The TLK3138 performs the parallel-to-serial, serial-to-parallel conversion, and clock extraction functions for a physical layer interface
|
TLK3138 |
| Gbps per Serial Channel(Min) |
3.125 |
| Gbps per Serial Channel(Max) |
3.125 |
| Power Consumption(Nom)(mW) |
2720 |
| Number of Serial Channels |
8 |
| Parallel Bus Width |
32 |
| Parallel I/F |
SSTL,HSTL (XGMII) |
| Serial I/F |
XAUI |
| Operating Temperature Range(C) |
0 to 70 |
| Pin/Package |
484BGA |
| Power Supply(V) |
0.75,1.2,1.5,2.5 |
| Vid(Min)(Vp-p) |
0.1 |
| Vid(Max)(Vp-p) |
2.0 |
| Vod(Min)(Vp-p) |
0.065 |
| Vod(Max)(Vp-p) |
1.575 |
TLK3138 特性
- Eight Channel 3.125 Gbps Transceiver
- Contains Two Complete IEEE P802.3ae-2002 10 Gbps Ethernet XGXS(1) (XAUI) Compliant Cores
- XAUI (Serial side) Channel Redundancy Mode Support: Fast Switching from Primary to Secondary XAUI/Channel with Provisionable Error Character or Local Fault Code Insertion at Switch Time
- XGMII (Parallel side) Channel Redundancy Mode Support: Fast Switching from Primary to Secondary XGMII/Channel with Provisionable Error Character or Local Fault Code Insertion at Switch Time
- Serial Side Transmit Pre-emphasis and Receive Adaptive Equalization to Allow Extended Backplane Reach
- Selectable Full Duplex Serial Side Retimer Mode
- Full Datapath Loopback Capability (Serial/Parallel Side)
- Support PRBS 27-1 and 223-1 Generate/Verify. Support Standard Defined CJPAT, CRPAT, High Frequency, Low Frequency, and Mixed Frequency Testing
- XGMII: HSTL Class 1 I/O with On-chip 50-Ω Termination on Inputs/Outputs (1.5-V Power Supply)
- XGMII: Support Receive (Output) Aligned/Centered Timing Modes, and Transmit (Input) Source Centered Mode
- Supports Jumbo Packet (9600 byte maximum) Operation
- Align Character Skew Support of 30 bit Times at Chip Pins
- Dual MDIO: IEEE 802.3ae Clause 45 Compliant Management Data Input / Output Interface (1.2-V and 2.5-V I/O)
- 1.2-V Core, 1.5-V HSTL I/O Supply, and 2.5-V LVCMOS and Bias Supply
- JTAG: IEEE 1149.1 Test Interface
- ±200 ppm Clock Tolerance in XAUI Transmit and Receive Datapaths
- Diagnostic LED Output Interface
- 130-nm CMOS Technology
- Package: PBGA 484, 23×23mm, 484 ball, 1mm Pitch
- 2.42 W Typical Power Dissipation (Dual XAUI Mode, Input HSTL Termination Disabled)
TLK3138 芯片订购指南
| 器件 |
状态 |
温度 |
价格 |
封装 | 引脚 |
封装数量 | 封装载体 |
丝印标记 |
| TLK3138GDU |
ACTIVE |
0 to 70 |
45.00 | 1ku |
BGA (GDU) | 484 |
60 | JEDEC TRAY (10+1) |
|
| TLK3138ZDU |
ACTIVE |
0 to 70 |
45.00 | 1ku |
BGA (ZDU) | 484 |
60 | JEDEC TRAY (10+1) |
|
TLK3138 质量与无铅数据
| 器件 |
环保计划* |
铅/焊球涂层 |
MSL 等级/回流焊峰 |
环保信息与无铅 (Pb-free) |
DPPM / MTBF / FIT 率 |
| TLK3138GDU |
TBD |
SNPB |
Level-4-220C-72 HR |
TLK3138GDU |
TLK3138GDU |
| TLK3138ZDU |
Pb-Free (RoHS) |
SNAGCU |
Level-4-260C-72HRS |
TLK3138ZDU |
TLK3138ZDU |
TLK3138 应用技术支持与电子电路设计开发资源下载
- TLK3138 数据资料 dataSheet 下载.PDF
- TI 德州仪器串行器和解串器选型与价格 . xls
- 所选封装材料的热学和电学性质 (PDF 645 KB)
- 使用数字隔离器设计隔离式 I2C 总线接口 (zhct119.PDF, 339 KB)
- 高性能SERDES及其在CPRI 接口的应用分析 (zhca076.HTM, 8 KB)
- 1Q 2011 Issue Analog Applications Journal (slyt399.PDF, 964 KB)
- 接口选择指南 (Rev. D) (PDF 2994 KB)
- Signaling Rate vs. Distance for Differential Buffers (PDF 420 KB)
- Q1 2009 Issue Analog Applications Journal (slyt319.PDF, 1.39 MB)
- Isolated RS-485 Reference Design (PDF 80 KB)
- 无铅组件涂层的保存期评估 (PDF 1305 KB)
- Analog Signal Chain Guide (8.62 MB)
- Industrial Interface IC Solutions (101 KB)
TLK3138 工具和软件