TLK3118 10 千兆以太网冗余 XAUI 收发器
The TLK3118 is a flexible, redundant XAUI serial transceiver that is compliant to 10-Gbps Ethernet XAUI specification. The TLK3118 provides high-speed bi-directional point-to-point data transmissions with up to 12.5 Gbps of raw data transmission capacity. The primary application of this device for use in backplanes and front panel connections requiring redundant 10Gbps connections over controlled impedance media of approximately 50 
. The transmission media can be printed circuit board (PCB) traces, copper cables or fiber-optical media. The ultimate rate and distance of data transfer is dependent upon the attenuation characteristics of the media and the noise coupling into the lines.
The TLK3118 performs the parallel-to-serial, serial-to-parallel conversion, and clock extraction functions for a physical layer interface
|
TLK3118 |
| Gbps per Serial Channel(Min) |
2.5 |
| Gbps per Serial Channel(Max) |
3.125 |
| Power Consumption(Nom)(mW) |
2090 |
| Number of Serial Channels |
4 |
| Parallel Bus Width |
8,10 |
| Parallel I/F |
SSTL,HSTL (XGMII) |
| Serial I/F |
LVPECL |
| Operating Temperature Range(C) |
0 to 70 |
| Pin/Package |
400FCBGA |
| Power Supply(V) |
0.75,1.2,1.5,2.5 |
| Vid(Min)(Vp-p) |
0.25 |
| Vid(Max)(Vp-p) |
2.0 |
| Vod(Min)(Vp-p) |
0.73 |
| Vod(Max)(Vp-p) |
0.97 |
TLK3118 特性
- Redundant Quad 3.2-Gbps Transceiver Configurable as 10-Gbps Attachment Unit Interface (XAUI) Transceiver
- IEEE P802.3ae-2002 10 Gbps Ethernet XGXS (XGMII Extender Sublayer) Compliant
- Redundancy: Fast Switching from Primary to Secondary XAUI channel with Provisionable Error Character or Local Code Fault Insertion at Switch Time
- XAUI: Transmit Pre-Emphasis and Receive Adaptive Equalization to Allow Extended Backplane Reach
- Selectable Full Duplex XAUI Retimer Mode
- Support PRBS 27-1 and 223 -1 Generate/verify. Support Standard Defined CJPAT, CRPAT, High Freq, Low Freq, and Mixed Freq testing
- XGMII: HSTL Class 1 I/O with On-Chip 50- Termination on Inputs/Outputs
- XGMII: Source Centered Timing
- Supports Jumbo Packet (9600 byte maximum) Operation
- Align Character Skew Support of 40 bit times at Chip Pins
- MDIO: IEEE 802.3ae Clause 45 Compliant Management Data Input/Output Interface
- 1.2-V Core Voltage Supply, 1.5-V HSTL I/O Supply, and 2.5-V LVCMOS and Bias Supply
- JTAG: IEEE 1149.1 Test Interface
- Fabricated in Advanced 130-nm CMOS Technology
- Package: Small Footprint 21x21mm, 400-Ball, Fine Pitch (1mm) PBGA
TLK3118 芯片订购指南
| 器件 |
状态 |
温度 |
价格 |
封装 | 引脚 |
封装数量 | 封装载体 |
丝印标记 |
| TLK3118GDV |
ACTIVE |
0 to 70 |
80.00 | 1ku |
FCBGA (GDV) | 400 |
60 | JEDEC TRAY (5+1) |
|
TLK3118 质量与无铅数据
| 器件 |
环保计划* |
铅/焊球涂层 |
MSL 等级/回流焊峰 |
环保信息与无铅 (Pb-free) |
DPPM / MTBF / FIT 率 |
| TLK3118GDV |
TBD |
SNPB |
Level-4-220C-72 HR |
TLK3118GDV |
TLK3118GDV |
TLK3118 应用技术支持与电子电路设计开发资源下载
- TLK3118 数据资料 dataSheet 下载.PDF
- TI 德州仪器串行器和解串器选型与价格 . xls
- 所选封装材料的热学和电学性质 (PDF 645 KB)
- 使用数字隔离器设计隔离式 I2C 总线接口 (zhct119.PDF, 339 KB)
- 高性能SERDES及其在CPRI 接口的应用分析 (zhca076.HTM, 8 KB)
- 1Q 2011 Issue Analog Applications Journal (slyt399.PDF, 964 KB)
- 接口选择指南 (Rev. D) (PDF 2994 KB)
- Signaling Rate vs. Distance for Differential Buffers (PDF 420 KB)
- Q1 2009 Issue Analog Applications Journal (slyt319.PDF, 1.39 MB)
- Isolated RS-485 Reference Design (PDF 80 KB)
- 无铅组件涂层的保存期评估 (PDF 1305 KB)
- Analog Signal Chain Guide (8.62 MB)
- Industrial Interface IC Solutions (101 KB)
TLK3118 工具和软件