The SN74LVTH32373 is a 32-bit transparent D-type latch designed for low-voltage (3.3-V) VCC operation, but with the capability to provide a TTL interface to a 5-V system environment. This device is particularly suitable for implementing buffer registers, I/O ports, bidirectional bus drivers, and working registers.
This device can be used as four 8-bit latches, two 16-bit latches, or one 32-bit latch. When the latch-enable (LE) input is high, the Q outputs follow the data (D) inputs. When LE is taken low, the Q outputs are latched at the levels set up at the D inputs.
A buffered output-enable (OE) input can be used to place the eight outputs in either a normal logic state (high or low logic levels) or the high-impedance state. In the high-impedance state, the outputs neither load nor drive the bus lines significantly. The high-impedance state and increased drive provide the capability to drive bus lines without interface or pullup components.
OE does not affect internal operations of the latch. Old data can be retained or new data can be entered while the outputs are in the high-impedance state.
Inputs can be driven from either 3.3-V or 5-V devices. This feature allows the use of these devices as translators in a mixed 3.3-V/5-V system environment.
When VCC is between 0 and 1.5 V, the device is in the high-impedance state during power up or power down. However, to ensure the high-impedance state above 1.5 V, OE should be tied to VCC through a pullup resistor; the minimum value of the resistor is determined by the current-sinking capability of the driver.
This device is fully specified for hot-insertion applications using Ioff and power-up 3-state. The Ioff circuitry disables the outputs, preventing damaging current backflow through the device when it is powered down. The power-up 3-state circuitry places the outputs in the high-impedance state during power up and power down, which prevents driver conflict.
Active bus-hold circuitry holds unused or undriven inputs at a valid logic state. Use of pullup or pulldown resistors with the bus-hold circuitry is not recommended
| SN74LVTH32373 | |
| Voltage Nodes(V) | 3.3, 2.7 |
| Technology Family | LVC |
| Rating | Catalog |
| 器件 | 状态 | 温度 | 价格（美元） | 封装 | 引脚 | 封装数量 | 封装载体 | 丝印标记 |
| SN74LVTH32373GKER | NRND | -40 to 85 | 3.20 | 1ku | LFBGA (GKE) | 96 | 1000 | LARGE T&R | |
| SN74LVTH32373ZKER | ACTIVE | -40 to 85 | 1.80 | 1ku | LFBGA (ZKE) | 96 | 1000 | LARGE T&R |
| 器件 | 环保计划* | 铅/焊球涂层 | MSL 等级/回流焊峰 | 环保信息与无铅 (Pb-free) | DPPM / MTBF / FIT 率 |
| SN74LVTH32373GKER | TBD | SNPB | Level-2-235C-1 YEAR | SN74LVTH32373GKER | SN74LVTH32373GKER |
| SN74LVTH32373ZKER | Green (RoHS & no Sb/Br) | SNAGCU | Level-3-260C-168 HR | SN74LVTH32373ZKER | SN74LVTH32373ZKER |