| # of Devices/ Channels | 2 |
| # of Taps | 64 |
| Memory Type | Non-Volatile |
| Bus Interface Type | SPI |
| Resistance Options (kΩ) | 10 |
| VCC Range (V) | 2.7 to 5.5 |
| VCC (min) (V) | 2.7 |
| VCC (max) (V) | 5.5 |
| DCP Dual Supply Range (V) | -2.7 to -5.5 |
| DCP Single Supply Range (V) | |
| Resistance Taper | Linear |
| Wiper Current (mA) | 6 |
| Wiper Resistance (Ω) | 40 |
| Supply Current (μA) | 1 |
| Max Operating Temp (°C) | 85 |
| End-to-End Tempco (ppm/°C) | 300 |
| Middlepoint Ratiometric Tempco | 20 |
| VL min. terminal voltage (V) | -5.5 |
| VH max. terminal voltage (V) | 5.5 |
The X9410 integrates two digitally controlled potentiometers (xDCP) on a monolithic CMOS integrated microcircuit.
The digitally controlled potentiometer is implemented using 63 resistive elements in a series array. Between each element are tap points connected to the wiper terminal through switches. The position of the wiper on the array is controlled by the user through the SPI bus interface. Each potentiometer has associated with it a volatile Wiper Counter Register (WCR) and 4 nonvolatile Data Registers (DR0:DR3) that can be directly written to and read by the user. The contents of the WCR controls the position of the wiper on the resistor array through the switches. Power up recalls the contents of DR0 to the WCR.
The xDCP can be used as a three-terminal potentiometer or as a two-terminal variable resistor in a wide variety of applications including control, parameter adjustments, and signal processing.