首页 > Intersil 英特矽尔 > 汽车用集成电路 > LNB 控制器

ISL6422

The ISL6422 is a highly integrated voltage regulator and interface IC, specifically designed for supplying power and control signals from advanced satellite set-top box (STB) modules to the low noise blocks (LNBs) of two antenna ports. The device is consists of two independent current-mode boost PWMs and two low-noise linear regulators along with the circuitry required for 22kHz tone generation, modulation and I2C device interface. The device makes the total LNB supply design simple, efficient and compact with low external component count.

Two independent current-mode boost converters provide the linear regulators with input voltages that are set to the final output voltages, plus typically 0.8V to insure minimum power dissipation across each linear regulator. This maintains constant voltage drops across each linear pass element while permitting adequate voltage range for tone injection.

The final regulated output voltages are available at two output terminals to support simultaneous operation of two antenna ports for dual tuners. The outputs for each PWM can be controlled in two ways:

All the functions on this IC are controlled via the I2C bus by writing 8-bit words onto the System Registers (SR). The same register can be read back, and 4-bits per output will report the diagnostic status. Separate enable commands sent on the I2C bus provide independent standby mode control for each PWM and linear combination, disabling the output into shutdown mode. Each output channel is capable of providing 750mA of continuous current. The overcurrent limit can be digitally programmed.

The External modulation input EXTM1, EXTM2 can accept a modulated Diseqc command and transfer it symmetrically to the output. Alternatively, the EXTM1 or EXTM2 pin can be used to modulate the continuous internal tone.

The FLT pin serves as an interrupt for the processor when an over temperature, overcurrent or backwards overcurrent fault conditions is detected by the LNB controller or when both channels are disabled by the I2C EN bits set low. The nature of the fault can be read of the I2C registers.

Applications
ISL6422 特点
ISL6422 芯片订购指南
芯片型号 产品状态 温度范围 封装尺寸图
ISL6422ERZ 量产 Extended Comm 40 Ld QFN
ISL6422ERZ-T 量产 Extended Comm 40 Ld QFN T+R
ISL6422EVEZ 量产 Extended Comm 38 Ld EPTSSOP
ISL6422EVEZ-T 量产 Extended Comm 38 Ld EPTSSOP T+R
ISL6422 应用技术支持与电子电路设计开发资源下载
  1. ISL6422 数据资料 datatSheet 下载.PDF
  2. Amplifier 放大器产品选型指南 . pdf
  3. ATE 系列产品选型指南 . pdf
  4. Auto 汽车电子选型指南 . pdf
  5. Communication 通信电路产品选型指南 . pdf
  6. Computing Power Management Products 计算机电源管理选型指南 . pdf
  7. DataConversion 数据转换器产品选型指南 . pdf
  8. DCP 数字电位器产品选型指南 . pdf
  9. Digital 数字电路产品选型指南 . pdf
  10. Display 显示器电路产品选型指南 . pdf
  11. Intel 英特尔嵌入式IC 应用解决方案 . pdf
  12. XILINX 赛灵思FPGA 应用解决方案 . pdf
  13. Interface 接口电路产品选型指南 . pdf
  14. Military 军事产品选型指南 . pdf
  15. Military /Space 军事/ 太空产品选型指南 . pdf
  16. Ordering Nomenclature Intersil 英特矽尔/ Xicor产品命名规则 . pdf
  17. pinPoint 系列产品选型指南 . pdf
  18. Power 电源管理器件产品选型指南 . pdf
  19. Special /Analog 特殊模拟器件产品选型指南 . pdf
  20. Switches/MUXes/Crosspoints 开关/ 多路复用器/ 交叉点开关产品选型指南 . pdf
  21. Timing /Circuits 定时电路产品选型指南 . pdf
  22. Video 视频产品选型指南 . pdf
  23. Voltage /Reference 电压基准产品选型指南 . pdf