首页 > Intersil 英特矽尔 > 电源管理器件 > 插拔控制器

ISL6111

The ISL6111 is designed for use in PCI and PCI-X applications where active current regulation protection of the motherboard from an abnormal PCI load card is desired.

With the addition of two discrete power MOSFETs and a few passive components, the ISL6111 provides power control for the four legacy supplies (-12V, +12V, +5V, +3.3V) to a PCI or PCI-X slot. This IC integrates the +12V and -12V current sensing and regulation switches. On the 25W capable 3.3V and 5V rails, current regulation (CR) protection is provided by sensing the voltage across external current-sense resistors and modulation of the gate voltage bias on the external N-channel power MOSFETs.

During initial power-up of the +12V bias supply, the ENABLE (EN), Power Good (PG), fault monitoring and reporting function functions are inhibited if bias voltage <10V. Once the FETs are enabled they are soft started into the load thus eliminating supply rail disturbances.

Upon a failure that quickly causes a load current greater than the programmed CR level on any voltage supply, the ISL6111 enters its current regulation (CR) mode, limiting the load current to the user programmed level for the user determined period of time. The CR level and duration are set by a single resistor and capacitor respectively. At the end of the CR duration all the switches will latch off pulling the outputs low along with the CRTIM (current regulation timer) and FLTN (fault not) pins indicating a latch-off due to an over current (OC) condition. If a severe OC condition should occur, then the ISL6111 immediately latches off all outputs and sets the FLTN output low.

During operation, if any of the positive voltages falls below the minimum PCI specified levels the power good (PG) output will pull low indicating a non compliant voltage to a load. PG is an open drain output as is FLTN.

The CRSET pin allows programming of the current regulation levels to be scaled up or down from the PCI specified levels via a resistor connected between the CRSET pin and ground.

All faults and latches are cleared by ENABLE being deasserted low.

ISL6111 特点
ISL6111 应用
ISL6111 芯片订购指南
芯片型号 产品状态 温度范围 封装尺寸图 潮湿敏感度等级MSL 美元价格US $
ISL6111CRZA 量产 民用级 20 Ld QFN 3 2.26
ISL6111CRZA-T 量产 民用级 20 Ld QFN T+R 3 2.26
ISL6111EVAL2 量产 评估板 N/A 价格录入中
ISL6111CR 停产 民用级 20 Ld QFN 1 N/A
ISL6111CR-T 停产 民用级 20 Ld QFN T+R 1 N/A
ISL6111 应用技术支持与电子电路设计开发资源下载
  1. ISL6111 数据资料 datatSheet 下载.PDF
  2. Power 电源管理器件产品选型指南 . pdf