AT83C5136xxx-DDW 带有32K系统内可编程USB存储器

Mask ROM (Kbytes)	32
USB Device	Yes
RAM (Bytes)	1280
F.max (MHz)	32
Vcc (V)	2.7-3.6
I/O Pins	18
UART	Yes
16-bit Timers	Yes
Watchdog	Yes
SPI	Yes
TWI	Yes
Pb-Free Packages	VQFN (Sawn) 32

AT83C5136xxx-DDW 概述

AT83C5134/35/36 are high performance ROM versions of the 80C51 single-chip 8-bit microcontrollers with full speed USB functions.
AT83C5134/35/36 features a full-speed USB module compatible with the USB specifications Version 2.0. This module integrates the USB transceivers and the Serial Interface Engine (SIE) with Digital Phase Locked Loop and 48 MHz clock recovery. USB Event detection logic (Reset and Suspend/Resume) and FIFO buffers supporting the mandatory control Endpoint (EP0) and 5 versatile Endpoints (EP1/EP2/EP3/EP4/EP5) with minimum software overhead are also part of the USB module.
AT83C5134/35/36 retains the features of the Atmel 80C52 with extended ROM cpacity (8/16/32Kbytes), 256 bytes of internal RAM, a 4-level interrupt system, two 16-bit timer/counters (T0/T1),a full duplex enhanced UART (EUART) and an on-chip oscillator.

• 8KB 系统内可编程Flash存储器：AT83C5134
• 16KB 系统内可编程Flash存储器：AT83C5135
• 32KB 系统内可编程Flash存储器：AT83C5136

AT83C5136xxx-DDW 特性

• • 80C52X2 Core (6 Clocks per Instruction)
  – Maximum Core Frequency 48 MHz in X1 Mode, 24 MHz in X2 Mode
  – Dual Data Pointer
  – Full-duplex Enhanced UART (EUART), TxD and Rxd are 5 Volt Tolerant
  – Three 16-bit Timer/Counters: T0, T1 and T2
  – 256 Bytes of Scratchpad RAM
  • 8/16/32-Kbyte On-chip ROM
  • 512 byte or 32-Kbyte EEPROM(1)
  • On-chip Expanded RAM (ERAM): 1024 Bytes
  • Integrated Power Monitor (POR/PFD) to Supervise Internal Power Supply
  • USB 2.0 Full Speed Compliant Module with Interrupt on Transfer Completion (12Mbps)
  – Endpoint 0 for Control Transfers: 32-byte FIFO
  – 6 Programmable Endpoints with In or Out Directions and with Bulk, Interrupt or
  Isochronous Transfers
  • Endpoint 1, 2, 3: 32-byte FIFO
  • Endpoint 4, 5: 2 x 64-byte FIFO with Double Buffering (Ping-pong Mode)
  – Suspend/Resume Interrupts
  – Power-on Reset and USB Bus Reset
  – 48 MHz DPLL for Full-speed Bus Operation
  – USB Bus Disconnection on Microcontroller Request
  • 5 Channels Programmable Counter Array (PCA) with 16-bit Counter, High-speed
  Output, Compare/Capture, PWM and Watchdog Timer Capabilities
  • Programmable Hardware Watchdog Timer (One-time Enabled with Reset-out): 50 ms to
  6s at 4 MHz
  • Keyboard Interrupt Interface on Port P1 (8 Bits)
  • TWI (Two Wire Interface) 400Kbit/s
  • SPI Interface (Master/Slave Mode) MISO,MOSI,SCK and SS are 5 Volt Tolerant
  • 34 I/O Pins
  • 4 Direct-drive LED Outputs with Programmable Current Sources: 2-6-10 mA Typical
  • 4-level Priority Interrupt System (11 sources)
  • Idle and Power-down Modes
  • 0 to 32 MHz On-chip Oscillator with Analog PLL for 48 MHz Synthesis
  • Industrial Temperature Range
  • Low Voltage Range Supply: 2.7V to 3.6V
  • Packages: Die SO28, QFN32, MLF48, TQFP64

AT83C5136xxx-DDW 订购型号

Part Number	Memory Size	Supply Voltage	Temperature Range	Package	Packing
AT83C5136xxx-PNTUL	32KB	2.7 to 3.6V	Industrial Green	QFN32	Tray
AT83C5136xxx-PLTUL	32KB	2.7 to 3.6V	Industrial Green	QFN/MLF48	Tray
AT83C5136xxx-TISUL	32KB	2.7 to 3.6V	Industrial Green	SO28	Stick
AT83C5136-RDTUL	32KB	2.7 to 3.6V	Industrial Green	VQFP64	Tray
AT83C5136xxx-DDW	32KB	2.7 to 3.6V	Industrial Green	Die	Inked Wafer
AT83EC5136xxx-PNTUL	32KB with 32-kbyte of EEPROM	2.7 to 3.6V	Industrial Green	QFN/MLF48	Tray
AT83EI5136xxx-PNTUL	32KB with 32-kbyte of EEPROM	2.7 to 3.6V	Industrial Green	QFN/MLF48	Tray

AT83C5136xxx-DDW 应用技术支持与电子电路设计开发资源下载

1. AT83C5136 数据手册DataSheet 下载. PDF
2. 80C51微控制器的复位输入. PDF (编号: Tech 8051 00049)
3. 80C51在系统Flash编程. PDF (编号:8051 00050)