SMP08 Low Droop Rate Octal Sample-and-Hold with Multiplexed Input

SMP08: Low Droop Rate Octal Sample-and-Hold with Multiplexed Input

The SMP08 is a monolithic octal sample-and-hold; it has eight internal buffer amplifiers, input multiplexer, and internal hold capacitors. It is manufactured in an advanced oxide isolated CMOS technology to obtain high accuracy, low droop rate, and fast acquisition time. The SMP08 has a typical linearity error of only 0.01% and can accurately acquire a 10-bit input signal to ±1/2 LSB in less than 7 microseconds. The SMP08's output swing includes the negative supply in both single and dual supply operation.

The SMP08 was specifically designed for systems that use a calibration cycle to adjust a multiple of system parameters. The low cost and high level of integration make the SMP08 ideal for calibration requirements that have previously required an ASIC, or high cost multiple D/A converters.

The SMP08 is also ideally suited for a wide variety of sample-and-hold applications including amplifier offset or VCA gain adjustments. One or more SMP08s can be used with single or multiple DACs to provide multiple set points within a system.

The SMP08 offers significant cost and size reduction over discrete designs. It is available in a 16-pin plastic DIP, or surface-mount SOIC package.

SMP08 功能框图

SMP08 芯片订购指南

产品型号	产品状态	封装	引脚	温度范围
SMP08FP	量产	16 ld PDIP	16	待定
SMP08FPZ	量产	16 ld PDIP	16	待定
SMP08FS	量产	16 ld SOIC	16	待定
SMP08FSZ	量产	16 ld SOIC	16	待定
SMP08FSZ-REEL	量产	16 ld SOIC	16	待定
SMP08GBC	量产	CHIPS OR DIE	-	待定

SMP08: Low Droop Rate Octal Sample-and-Hold with Multiplexed Input

SMP08 功能框图

SMP08 应用技术支持与电子电路设计开发资源下载