DRV8810  具有 DC-DC 转换器的组合电机驱动器
              DRV8810 描述
       The DRV8809/DRV8810 provides an integrated motor driver solution. The chip has four H-bridges internally and is configurable to eight different modes of combination motor driver control.
The output driver block for each H-bridge consists of N-channel power MOSFETs configured as full H-bridges to drive the motor windings. The stepper motor control has a 16-step mode programmable through the three-wire serial interface (SPI). The SPI input pins are 3.3-V compatible and 5-V tolerant.
The DRV8809/DRV8810 has three DC-DC switch-mode buck converters to generate a programmable output voltage from 1.5 V to 80% of VDIN (Channel A) or up to 10 V (for Channel B and Channel C), with up to 1.5-A load current capability. The outputs are selected using the C_SELECT terminal at start-up or using serial interface during operation.
An internal shutdown function is provided for overcurrent protection (OCP), short-circuit protection, overvoltage/undervoltage lockout (UVLO), and thermal shutdown (TSD). Also, the device has a reset function that operates at power on and at input to the In-Reset pin
              
                
                   | 
                  DRV8810 | 
                
                
                  | Vs(Min)(V) | 
                  7   | 
                
                
                  | Vs(Max)(V) | 
                  40   | 
                
                
                  | Output Current(Min)(A) | 
                  0.8   | 
                
                
                  | rDS(on)(Ohms) | 
                  0.5   | 
                
                
                  | Switching Frequency (Single-Ended)(kHz) | 
                  50   | 
                
                
                  | Operating Temperature Range(°C) | 
                  -10 to 64   | 
                
                
                  | Pin/Package | 
                  64HTQFP | 
                
       
              DRV8810 特性
              
                - Configurable to Eight Modes of Combination Motor Driver
                  
                      - Bipolar Stepper Motor Driver
                        
                            - 16-Step Current-Mode Control   
                            
 - 800-mA Average Output Current as Stepper Motor Drive
 
                        
                       - DC Motor Driver
                        
                            - 800-mA Maximum Continuous Current and 8-A/500-ns or 3-A/100-ms Peak Current   for Each DC Motor Drive
 
                        
                       - Low ON resistance Rds(ON) = 0.55 Ohm at TJ   = 25°C (Typ)
 
                  
                 - Three Integrated DC-DC Converters
                  
                      - On/Off Selectable Using C_SELECT Pin and Serial Interface   
                      
 - Outputs Programmable With External Resistor Network From 1.5 V to VDIN × 0.8     
                      
 - 1.5-A Output Capability for All Three Channels
 
                  
                 - 7-V to 40-V Operating Voltage Range for DC-DC Converters   
                
 - Two Serial Interfaces for Communications   
                
 - Thermally-Enhanced Surface-Mount 64-Pin QFP PowerPADTM Package 
                  (Eco-Friendly – RoHS and No Sb/Br)   
                
 - Power-Down Function (Deep-Sleep Mode)   
                
 - Reset Signal Output (Active Low)   
                
 - Reset (All Clear) Control Input
 
              
              DRV8810 芯片订购指南
              
                
                  | 器件 | 
                  状态 | 
                  温度 (oC) | 
                  价格(美元) | 
                  封装 | 引脚 | 
                  封装数量 | 封装载体 | 
                  丝印标记 | 
                
                
                  | DRV8810PAP | 
                  ACTIVE | 
                  -10 to 64 | 
                  5.40 | 1ku | 
                  HTQFP (PAP) | 64 | 
                  1 | JEDEC TRAY (5+1) | 
                  DRV8810 
                    1 | 
                
              
              DRV8810 质量与无铅数据
              
                
                  | 器件 | 
                  环保计划* | 
                  铅/焊球涂层 | 
                  MSL 等级/回流焊峰 | 
                  环保信息与无铅 (Pb-free) | 
                  DPPM / MTBF / FIT 率 | 
                
                
                  | DRV8810PAP | 
                  Green (RoHS & no Sb/Br)  | 
                  CU NIPDAU  | 
                  Level-3-260C-168 HR | 
                  DRV8810PAP | 
                  DRV8810PAP | 
                
              
              DRV8810 应用技术支持与电子电路设计开发资源下载
              
                - DRV8810 数据资料   dataSheet 下载.PDF 
 
                - TI 德州仪器运动/电机控制产品选型与价格 . xls 
 
                - PowerPADTM Thermally   Enhanced Package
                  
                   
                  (PDF    1040 KB)                
 
                - 全面认识开关型电源中的BUCK-BOOST功率级   (Rev. A)
                  
                   
                (PDF    2206 KB)
 
                - Shelf-Life Evaluation of Lead-Free Component Finishes  (PDF  1305 KB)
 
                - PowerPADTM Made Easy  (PDF  57 KB) 
 
                - 标准线性产品交叉参考 (Rev. D)
                  
                  
                   
                (PDF    1058 KB) 
 
                - 模数规格和性能特性术语表 (Rev. A) (PDF 1993 KB) 
                
 - 所选封装材料的热学和电学性质 (PDF 645 KB) 
                
 - 高速数据转换 (PDF 1967 KB) 
 
              DRV8810 相关工具 
              
                
                  | 名称 | 
                  型号 | 
                  公司 | 
                  工具/软件类型 | 
                
                
                  | DRV8810 评估模块 | 
                  DRV8810EVM | 
                  Texas Instruments | 
                  开发电路板/EVM |