TL751M12-Q1 汽车类单路输出 LDO、750mA、固定电压 (12.0V)、使能端、60V 负载突降保护

	TL751M12-Q1
Iout(Max)(A)	0.75
Vdo(Typ)(mV)	500
Iq(Typ)(mA)	60
Vin(Min)(V)	13
Vin(Max)(V)	26
Vout(Min)(V)	12
Vout(Max)(V)	12
Output Capacitor(uF)	10
Fixed Output Options(V)	12
Pin/Package	5DDPAK/TO-263, 5PFM
Rating	Automotive
Regulated Outputs(#)	1

TL751M12-Q1 描述

The TL750M and TL751M series are low-dropout positive voltage regulators specifically designed for automotive applications. The TL750M and TL751M series incorporate onboard overvoltage and current-limiting protection circuitry to protect the devices and the regulated system. Both series are fully protected against load-dump and reverse-battery conditions. Load-dump protection is up to a maximum of 60 V at the input of the device. Low quiescent current, even during full-load conditions, makes the TL750M and TL751M series ideal for use in applications that are permanently connected to the vehicle battery. The TL750M and TL751M series offers 5-V, 8-V, and 12-V options. The TL751M series has the addition of an enable (ENABLE) input.

TL751M12-Q1 特性

• Qualified for Automotive Applications
• Low Dropout Voltage, Less Than 0.6 V at 750 mA
• Low Quiescent Current
• TTL- and CMOS-Compatible Enable on TL751M Series
• Load-Dump Protection
• Overvoltage Protection
• Internal Thermal Overload Protection
• Internal Overcurrent-Limiting Circuitry

TL751M12-Q1 芯片订购指南

器件	状态	温度 (oC)	价格（美元）	封装 | 引脚	封装数量 | 封装载体	丝印标记
TL751M12QKTTRQ1	ACTIVE	-40 to 125	0.90 | 1ku	DDPAK/TO-263 (KTT) | 3	500	TL760M33Q1
TL751M12QKVURQ1	ACTIVE	-40 to 125	0.75 | 1ku	PFM (KVU) | 3	2500	760M33Q1

TL751M12-Q1 质量与无铅数据

器件	环保计划*	铅/焊球涂层	MSL 等级/回流焊峰	环保信息与无铅 (Pb-free)	DPPM / MTBF / FIT 率
TL751M12QKTTRQ1	Pb-Free (RoHS)	CU SN	N/A for Pkg Type	TL751M12QKTTRQ1	TL751M12QKTTRQ1
TL751M12QKVURQ1	Pb-Free (RoHS)	CU SN	N/A for Pkg Type	TL751M12QKVURQ1	TL751M12QKVURQ1

TL751M12-Q1 应用技术支持与电子电路设计开发资源下载

1. TL751M12-Q1 数据资料 dataSheet 下载.PDF
2. TI 德州仪器LDO低压差线性稳压器驱动器选型与价格参考 . xls
3. Dual MOSFET Driver (PDF 498 KB)
4. 全面认识开关型电源中的BUCK-BOOST功率级 (Rev. A) (PDF 2206 KB)
5. LDO PSRR Measurement Simplified (PDF 140 KB)
6. LDO Noise Demystified (PDF 782 KB)
7. 标准线性产品交叉参考 (Rev. D) (PDF 1058 KB)
8. 模数规格和性能特性术语表 (Rev. A) (PDF 1993 KB)
9. 所选封装材料的热学和电学性质 (PDF 645 KB)
10. 高速数据转换 (PDF 1967 KB)